Programming manual
Configuring the system
25
8.3.3
View the devices on the RS485 BUS
From panel:
<key>, Programming, <code>, Configuration, View Configuration, RS485 BUS,
or:
<key>, 8, <code>, 1, 1, 3
Note:
The description will be shown only if the repeater is present in the configuration.
Use keys
S
and
T
to navigate through the
devices in the configuration.
8.3.4
Viewing I/O expansion boards
From panel:
<key>, Programming, <code>, Configuration, View Configuration, Optional boards,
or:
<key>, 8, <code>, 1, 1, 4
8.4
Manual configuration at panel
The manual configuration option (from the control panel) allows you to work on the parameters of the
loops, the BUS RS485 devices, the I/O expansion board and the dialer and on the loop-device parameters.
8.4.1
Modifying the loop parameters manually
From panel:
<key>, Programming, <code>, Configuration, Modify Configuration, Manual Configuration,
Loop,
or:
<key>, 8, <code>, 1, 2, 2, 1
Use keys
S
and
T
to navigate through the
loops.
Press
on the loop you wish to configure/
modify.
Press
on the
Loop Parameters
to go to the
Loop configuration phase.
8.4.2
Adding/Modifying a device
From panel:
<key>, Programming, <code>, Configuration, Modify Configuration, Manual Configuration ,
Loop, x Loop x, Add/Modify Point,
or:
<key>, 8, <code>, 1, 2, 2, 1, x, 2
Press
on the first line to add a new device.
R e p e a t e r n
i n C o n f i g u r a t i o n : Y N
< D e s c r i p t i o n r e p e a t e r >
L o c a l I / O
i n C o n f i g u r a t i o n : Y N
J
1 L o o p 1 < L o o p D e s c r i p t i o n >
2 L o o p 2 < L o o p D e s c r i p t i o n >
3 L o o p 3 N o t a v a i l a b l e
4 L o o p 4 N o t a v a i l a b l e
L
J
1 L o o p P a r a m e t e r s
2 A d d / M o d i f y P o i n t
3 R e m o v e P o i n t
J
0 0 0 N e w D e v i c e L o o p n . x
0 0 1 < T y p e D e s c r i p t i o n > < D e s c r i p t i o n >
0 0 2 < T y p e D e s c r i p t i o n > < D e s c r i p t i o n >
0 0 3 < T y p e D e s c r i p t i o n > < D e s c r i p t i o n >
