36
Installation
Anti-intrusion control panels
4-9-4
Connecting Air2-MC300 wireless detectors
The two terminals,
T1
or
T2
, on the Air2-MC300 magnetic contact are configurable as either
input or open-collector output.
Configuring the terminals as inputs allows management of standard zone balancing (N.O.,
N.C., single balancing, double balancing) and also direct interfacing with roller-blind and shock
sensors.
For the connection and balancing of sensors connected to terminals
T1
and
T2
of the Air2-
MC300 device, refer to paragraphs
4-3-1
,
4-3-2
,
4-3-3
,
4-4-1
and
4-4-2
.
In order to comply with the EN 50131 series of standards, double balancing is required when
either terminal
T1
or
T2
is configured as an input.
It is necessary for the GND terminal of the Air2-MC300 device to be connected to negative
(
GND
) of the power supply of the sensor connected to terminal
T1
or
T2
.
4-9-5
Installing the Air2-FD100
1. Choose a suitable mounting placement.
2. Hold the base to the chosen mounting placement and mark the mounting locations.
Insert the battery ensuring that the polarity is correct.
3. Attach the battery cover.
4. Position the detector over the base and, pressing lightly, turn it clockwise until notch
[
A
]) aligns with notch [
B
] attaching the detector to the base; turn it a little further until
notch [
A
] aligns with notch [
C
], in order to allow the base to close the tamper micros-
witch.
5. Enroll the device.
4-9-6
Enrolling wireless devices
The final installation phase of each wireless device is the enrollment and configuration on the
control panel.
This phase involves a procedure that can be carried out using different modalities and
depending on the registration of the Sol installation to Inim Cloud service:
• using only the InimTech Security App, in this case registration to Inim Cloud is necessary;
• using only the Sol/STUDIO software, in this case registration to Inim Cloud is not
necessary;
• using the Sol/STUDIO software and the InimTech Security App, in this case registration to
Inim Cloud is not necessary.
Programming
via InimTech
Security App
1. Start the App and access the side menu using the
button shown top left.
2. Access the “Programming” section.
3. Follow the guided procedure for fast system configuration up to the request to program
the wireless peripherals.
4. In the section reached by means of the
button it is possible to add new wireless
devices.
5. Activate the Smartphone camera you will use for reading the QR code of the device to
be enrolled. The application recognizes automatically the various devices and puts them
in a list.
6. On exiting the video capture mode, the application will show a list of recognized
devices. In this section it is necessary to complete the configuration of the.devices in
order to proceed. The devices which are not completed will have the description bor-
dered in red.
7. Access the last section of the guided procedure.
This section changes in relation to the registration of the Sol control panel to Inim Cloud
service.
Alarm
+12V GND
Air2-MC300
Detector
Power
supply
A
B
C