Installation manual
Installation
35
4-9
Installing wireless devices
4-9-1
Installing the Air2 remote-control key
The Air2 requires enrolling only.
If it becomes necessary to replace the rubber button cover or battery, work through the
following steps.
1. Remove the securing screw on the back of the keyfob and open the device.
2. Remove the rubber button cover.
3. Replace the rubber button cover/battery as required.
4. Close the device and replace the enclosure screw.
5. Enroll the key.
4-9-2
Installing the Air2-MC200
1. Choose a suitable mounting placement.
ATTENTION!
Ferromagnetic materials which are located in the vicinity of the mounting position can
influence the magnetic field and can result in the reduced operating capacity of the device.
2. Using a flat-bladed screwdriver in the enclosure screw location, push open the enclo-
sure and separate the two parts.
3. Hold the base to the chosen mounting placement and mark the screw holes and tamper
protection position.
4. Using the screws, secure the base and the tamper protection in position.
5. Insert the battery, ensure you respect the proper polarity.
6. Enroll the device.
7. If you wish to fit the magnet, work through the steps described in the previous para-
graph.
8. Re-attach the cover to the base of the contact and replace the enclosure screw.
4-9-3
Installing the Air2-MC300
1. Choose a suitable mounting location.
ATTENTION!
Ferromagnetic materials which are located in the vicinity of the mounting position can
influence the magnetic field and can result in the reduced operating capacity of the device.
2. Open the enclosure by pushing lightly on the anchor tab and separate the two parts.
ATTENTION!
Be careful not to remove the circuit from its housing.
3. If you are using terminals
T1
and
T2
, pass the cables through the cable entry and con-
nect them. Take care to ensure that inadmissible cable filaments do not come into con-
tact with each other or with the + clip of the battery.
4. Hold the base to the chosen mounting placement and mark the points for the base
attachment and tamper protection.
5. Using the screws, secure the base and the tamper protection in position.
6. If you wish to fit the magnet by means of the screws (included) or change the magnet
base for installation purposes, remove the base with the help of a flat-bladed screw-
driver.
Note
For proper installation of the magnet, the manufacturer strongly advises that the upper part of the
contact cover is aligned with that of the magnet.
7. Position the magnet base on the desired side (long or short) of the magnetic contact at
a distance of about 2mm.
If you are using the long side, centre the notches on the side of the base in such as way
as to obtain the correct alignment and functioning capacity of the magnet.
In the case of the short side, align the magnet with the detector itself.
8. Using the screws or the adhesive tape, attach the magnet.
9. Remove the battery tab.
10. Re-attach the cover to the base of the contact and replace the enclosure screw.
11. Enroll the device.