Technical specification
100-240V~ 50/60 Hz.,socket E27, max. 75W.
recommended bulb: PAR30 (short neck)
Dimmable (depend on light bulb, dimmer not included)
Suitable for bulbs of the classes A++ - E.
Minimum distance from nearest lit surface 0,3m.
A defective lamp must be disposed as electronic
scrap, it must not get into domestic waste.
Any repairs that may become necessary must be carried
out by a professional electrician.
In case of damage caused by disregarding these operating
instructions, improper commissioning and/or construction
change, e.g. due to foreign components, handling
or external interference, the warranty claim is void.
English
9
English
Tighten the screws, ensuring that the base plate is exactly
centred over the socket box. Replace the cover (
4
) by
pressing it gently onto the base plate (
5
) until the magnet
(
8
) clicks into position. Adjust the position of the cover
by turning it slightly so that the ball (
9
) is fully visible in the
large aperture (
10
).
Screw in a Bulb and replace the fuse or switch it back on.
Caution:
The angle of the lamp can be corrected by
loosening the screws and turning the base plate.
③
Spock
is freely adjustable via the ball-joint, but please take
care not to damage the cable by turning the lamp too far.
Version B - Surface mounting
Important:
Take care to ascertain the exact position
of the mains cable, so as to avoid drilling into it. Do not
attach the lamp to a damp and/or conductive surface!
Preparations for assembly
Use the socket box (
11
) supplied as a guide for marking
the drill holes. Drill the two 6 mm-diameter holes. Insert
the S6 plugs (
12
) and attach the box, screwing it firm-
ly into position. Remove a 12 cm section of the outer
covering from the mains cable (
13
) and strip about 5 mm
from the ends of the three leads.
④
Assembly
Same procedure as for version A.
8
