AAS2000IKI01
65
Installation manual
Ingeteam Power Technology, S.A.
•
Ratchet and spanner 17 (M12) for AC and DC connections.
To fix the electronics block:
•
Ratchet 13 (M8) for fixing the electronics block.
•
Ratchet 7 (M4) for removing the top cover.
Fasteners
Fan housing
Electronics block
Fasteners
Proceed in the following order:
1.
Disconnect the unit from the power grid and the PV array.
2.
Wait at least 10 minutes for the capacitances to discharge.
3.
Check that there are no voltages inside the unit.
4.
Remove the “Fan housing”.
5.
Disconnect the “Power cables” at the bottom of the block.
6.
Disconnect the wires entering the “Terminal strip” from outside the block.
7.
Disconnect communication boards or analogue inputs.
8.
Disconnect the display cable.
9.
Unscrew the four anchor points or “fastenings”.
10. Remove it.
For reassembly, we will perform the same steps in reverse order and finally will need to set the electronic blocks:
1.
Mount it
2.
Tighten the fixing screws
3.
Disconnect the display cable
4.
Connect communication boards or analogue inputs.
5.
Connect the wires entering the “Terminal strip” from outside the block.
6.
Connect the “Power cables” at the bottom of the block.
7.
Fit the “Fan housing”.
8.
Connecting the unit to the PV array.