for insulation distances and leakage paths for the voltages used.
The tools and/or equipment used in handling tasks must have double reinforced insulation (Class II).
4.4.1. General risks existing and preventive measures
Impact against immovable objects
•
Inform workers of the risk.
•
Adequate lighting.
•
Work with care.
•
Keep sufficient distance to prevent contact with the part causing the risk.
Knocks, punctures and cuts from objects and/or tools
•
Keep the lid closed if not working on the inside.
•
Adequate lighting.
•
Order and cleanliness.
•
Mandatory use of hard hat, safety footwear and gloves when necessary.
Flying particles (fan)
•
Recommended use of anti-impact glasses when accessing the fan inlet and outlet zones.
•
Electrical danger.
•
Comply with that laid down in the Sections “4.4.3. Personal Protection Equipment (PPE)” and “Important
•
Inform the worker of the risk.
•
Comply with the legislation applicable to the installation in which the unit is located, both that for the type
of installation and the country where it is located.
4.4.2. Additional risks and measures in handling tasks
Thermal contact
•
Inform workers of the risk.
•
Recommended use of gloves.
•
Disconnect the power and wait 10 minutes for the hot parts inside the unit (internal radiator) to cool.
4.4.3. Personal Protection Equipment (PPE)
The preventive maintenance tasks involve Inspection, Control and/or Handling actions, depending on
each case.
Inspection
The use of safety footwear to standard
EN 345-1:1992
is mandatory. The use of kid leather type gloves is also
mandatory.
Control
The use of safety footwear to standard
EN 345-1:1992
is mandatory. The use of kid leather type gloves is also
mandatory.
Handling
The use of safety footwear to standard
EN 345-1:1992
is mandatory. The use of kid leather type gloves is also
mandatory.
It is also mandatory to use dielectric gloves meeting standard
EN 60903-1992
and protective face mask against
AAY2000IKI04
23
Installation manual
Ingeteam Power Technology, S.A.
Summary of Contents for Ingecon mWind 2.5
Page 1: ...Ingecon Wind Installation manual...
Page 55: ...Notes...
