29
HEADLIGHTS
To replace the headlight bulb:
1. Remove
the
two
screws and retainers.
2. Remove the headlight receptacle.
3. Push in and turn counterclockwise to remove the
bulb.
4. Push in and turn clockwise to install the new
bulb.
5. Install the receptacle. Put one gasket between
the lens and grille. Put the other gasket in the
groove between the lens and the receptacle.
6. Install the retainers with the mounting screws.
NOTE:
The new bulb will not illuminate until the
receptacle has a ground connection.
FUSE
The 30 amp fuse is located next to the hydraulic oil
reservoir. This fuse protects all circuits except the
starter motor.
Use the following procedure to replace a fuse:
a. TO REMOVE: Hold the fuse holder while you pull
up on the fuse.
b. Inspect and clean the contacts of the fuse holder
(if required).
c. TO INSTALL: Push firmly into the fuse holder.
ATTACHMENT DRIVE CLUTCH BREAK-IN PROCEDURE
To insure normal clutch lining wear life, the lining
must be burnished using the following procedure:
1. Install the mower or snow blower attachment.
2. Run engine at 1/2 throttle.
3. Engage and disengage clutch 5 times.
10 seconds on, 10 seconds off.
4. Increase engine speed to 3/4 throttle.
5. Engage and disengage clutch 5 more times.
10 seconds on, 10 seconds off.
FIGURE 17
FIGURE 18
casecoltingersoll.com
Summary of Contents for 4018
Page 2: ...2 casecoltingersoll com ...
Page 38: ...casecoltingersoll com ...
