Ingersoll-Rand THERMO KING E-200 Series, Installation Manual

Page: 44 / 52

44
TK 61694-18-IM-EN
Discharge Pressure Regulator (DPR) Adjustment
Procedures - MAX
W WA AR RN NIIN NG G
E Eq qu uiip pm me en ntt D Da am ma ag ge e!!
L Lo ow we err sse ettttiin ng gss cca an n b be e sse elle ecctte ed d b ba asse ed d o on n llo occa all p prre effe erre en ncce ess tto o o op pttiim miizze e h he ea attiin ng g o op pe erra attiio on n.. H HIIG GH HE ER R v va allv ve e
sse ettttiin ng gss tth ha an n ssp pe ecciiffiie ed d w wiillll lle ea ad d tto o ssy ysstte em m m ma allffu un nccttiio on n iin nccllu ud diin ng g o op pe erra attiio on n iin ntte errrru up pttiio on n w wh he en n b bo ox x iiss w wa arrm m
((m mo otto orr o ov ve errccu urrrre en ntt cco on nfflliicctt w wiitth h iin nv ve errtte err lliim miittss))..
The DPR setting is factory set, however, the below procedure can be used to check the setting in the case of any doubt.
N No otte e:: The measurement of the High Pressure > 6 bar (87 psig) does not necessarily mean that the DPR is set > 6 bar (87
psig). To get a more precise measurement of the DPR setting follow the procedure below in the exact order that it
is listed:
1. Cool down the box to -20º C (-4º F).
2. Change operation to heating mode.
3. Attach a gauge manifold to the suction service port (1) and the discharge service port (2). A low loss fitting must be
used on the hose connected to the discharge service port. (See illustration below).
4. Operate the unit in high speed heat until the system pressures stabilize.
5. Check High Pressure with the gauges as follows:
a. Check the discharge pressure on the gauge attached to the discharge service port.
b. A pressure of >= to 6 bar (87 psig) is required for the DPR to function, however It should be within a range of 6
bar (87 psig) to 10 bar (145 psig) and no higher.
c. If the setting is incorrect, remove the protective cap and try to adjust the DPR (3) to the correct setting.
6. Remove the gauges to return the unit to normal operation.