Ingersoll-Rand THERMO KING E-200 Series, Installation Manual

Page: 19 / 52

TK 61694-18-IM-EN
19
Installing the Filter Drier and Sight Glass
C CA AU UT TIIO ON N
S Se errv viicce e P Prro occe ed du urre e!!
T Th hiiss u un niitt iiss ssu up pp plliie ed d w wiitth h sse errv viicce e v va allv ve ess ccllo osse ed d.. T Th he e IIn nsstta alllle err h ha ass tto o m mo ou un ntt tth he e ffiilltte err d drry ye err a an nd d ssiig gh htt g glla assss
b be effo orre e cch ha arrg giin ng g tth he e u un niitt w wiitth h rre effrriig ge erra an ntt .. A Afftte err rre effrriig ge erra an ntt cch ha arrg ge e,, tth he e sse errv viicce e v va allv ve ess ssh ha allll b be e lle efftt o op pe en n a an nd d a a
tta am mp pe err p prro oo off sse ea all ffiitttte ed d ((a ass rre ecco om mm me en nd de ed d b by y E EN N 3 37 78 8--2 2)) ((a av vo oiid d rriisskk tth ha att n no ott--e ed du ucca atte ed d u usse err ccllo osse ess v va allv ve ess
ttrra ap pp piin ng g lliiq qu uiid d iin n tth he e d drry ye err))..
1. Locate the Filter Drier/Sight Glass assembly in your installation kit.
2. Grease the o-rings prior to installing them onto each end of the assembly.
3. Install the assembly with appropriate wrench (hand tighten).
4. Perform vacuum procedure of air from the Filter Drier and Sight Glass via the service valves on either side of this
assembly.
IIm mp po orrtta an ntt:: See Section 10 - System Evacuation Procedures and Section 12 - System Charging Procedures in the
Thermo King Vehicle Powered Truck Installation Standards and Procedures Guide (TK 61588). THESE
PROCEDURES MUST BE FOLLOWED!
Figure 7. Installing the Filter Drier and Sight Glass