Ingersoll-Rand QA6 series, Maintenance Information, Page: 30 / 94

30 16601056_ed1
Adjustment of Motor Module
Place Motor in motor clamp tool fixture 80187388 / 16604845 (Depending on QA6 or QA8). Align Motor Assembly so that the pin (7B) in rear
endplate assembly locates into pin hole at the bottom of fixture.
2. Thread Back Cap onto fixture. Tighten it to 40 nm (30 ft-lb) using a wrench.
Note
: Motor clamp tool fixture simulates motor in actual tool assembly. Unclamped motors may not be properly spaced and cause motor to
overheat or bind.
1.