Ingersoll-Rand QA6 series, Maintenance Information, Page: 26 / 94

26 16601056_ed1
3. Using 3mm Hex key, unscrew adjusting screw.
4. Hold Motor firmly in hand, strike mallet on rotor spline to drive rotor (1) and rear endplate assembly out of front endplate (9). Remove front
endplate (with wave washer and bearing) and cylinder assembly from motor module.
5. Remove Vanes (2A) Qty # 5 from rotor and using degreaser clean all surfaces of rotor and endplate.
6. Remove rear endplate assembly (7) from rotor.
Note : It is not a hard press, so gently press out rotor with a pin<7mm from endplate.
Assembly Instructions for Motor Module
Note : Replacement of motor parts may change shut off operation of tool. We recommend ordering new pushrod (132017).
1. Completely clean rotor and cylinder with a degreaser agent, it may be necessary to use a light brush to clean rotor and pin with degreaser.
2. Place Wave washer (3) in front end plate (9) counter bore.