Ingersoll-Rand 70P3, Operation And Maintenance Manual, Page: 22 / 23

22
MAINTENANCE SECTION
15. Grasp the flats of the Housing in vise jaws with the
output spindle downward. Remove the Rear Liner
Cover Assembly and put grease in the central
opening of the Cover. (Refer to Dwg. TPD1289)
(Dwg. TPD1289)
GREASE
16. Reinstall the Cover Assembly and use a hex wrench
to push it below the threads at the rear of the
Housing. (Refer to Dwg. TPD1290)
(Dwg. TPD1290)
PUSH DOWN
17. Install the Housing Cap (44) and using the spanner
plug furnished in the Tool Kit, tighten the Cap
between 58–65 ft–lb (78–88 Nm) torque.
(Refer to Dwg. TPD1291)
(Dwg. TPD1291)
SPANNER PLUG
CLOCKWISE TO TIGHTEN
18. Make certain the Drive Shaft rotates freely and then
fill the mechanism with fluid and reassemble the tool
as instructed in the section, CHANGING THE
MECHANISM FLUID.
19. Install the Main Shaft Bushing (67) in the Mechanism
Cover (66).
20. Install the Mechanism Cover Gasket (70) on the front
of the Motor Housing Assembly.
21. Install the Mechanism Cover on the Gasket and
Motor Housing and secure it with the Mechanism
Cover Washers (72) and Mechanism Cover Bolts
(68). Tighten to 35–52 ft–lb (44–72 Nm) torque.