MS-SVX039A-EN
21
Configuration
Using the Wireless Remote Control
To change system configurations using the Wireless Remote Control, follow this procedure:
1.
Remove the batteries from the remote control, and re-insert them while pressing the Temp+ and
Temp- buttons simultaneously (refer to
Figure 4, p. 21
).
The first 2-digit segment of a 24-digit sequence will appear on the wireless remote control
display, as shown:
2. To advance to the next 2-digit segment, press the
Mode
button (
Figure 4, p. 21
). Continue
pressing the
Mode
button until the two-digit segment appears that corresponds to the option
setting or address setting you want to view or change.
Each 2-digit segment is differentiated from the others by a combination of operation mode
(Auto/Cool/Dry...) and ON/OFF icons, as shown below. (See “The 2-Digit Segments,” for more
detailed information.)
3. To change the value of the left digit on the display, press the
Fan
down button.
To change the value of the right digit on the display, press the
Fan
up button.
Note:
Values and their corresponding settings are listed in the following pages of this section
of the manual.
4. To save the setting, press the
Power
button twice.
5. To restore the wireless remote control to normal operating mode, remove the batteries from
the remote control. Then re-insert them.
Figure 4.
Wireless Remote Control
Digits 2 and 3
Digits 4 and 5
Digits 6 and 8
...and so on, through
digits 23 and 24.
Note:
Digits 1, 7, 13, and 19 do not appear and are not used for configuration.
Mode button
Fan up
Fan down
Power button
2-digit segment
Note:
The wireless remote control may
look different from the illustration,
depending on the model.
Temp up
Temp down
