Ingenico iCT 250, Manual, Page: 2 / 33

2 | P a g e
TABLE OF CONTENTS
INSTALLING THE HARDWARE FOR TCP/IP 4
H
ARDWARE
C
ONNECTIONS
4
GETTING THE IP, SUBNET MASK, GATEWAY IP, AND DNS IP 7
CONFIGURING THE STATIC IP ADDRESS IN THE PIN PAD 12
CONFIGURING CRE/RPE FOR USE WITH GLOBAL PAYMENTS EMV 16
PERFORMING A CREDIT CARD SALE 17
PERFORMING A CREDIT CARD SALE USING AN EMV ENABLED CARD 19
PERFORMING A CREDIT CARD SALE USING A CONTACTLESS ENABLED CARD 21
PERFORMING A DEBIT CARD SALE 23
PERFORMING A MANUAL ENTRY SALE 25
PERFORMING A RETURN 28
PERFORMING A VOID 29
PERFORMING A SETTLEMENT/BATCH CLOSE 31
Important Notes – Please Read!

CRE must be on version 12.8001 or higher to use the ICT-250

Each ICT 250 device needs its own wired internet connection (unique IP address). It cannot use the same internet cable
connected to the PC. Prior to installation, make sure there are enough additional internet connections for each PAX device
you will be installing.

Each register running card transactions must have its own ICT-250 device; ICT-250 devices may not be shared among
registers.

Credit card settlements must be done in CRE on every station where an ICT-250 device is connected and you must enter a
password on the pinpad to begin the settlement.

The ICT-250 device must have settings pre-configured and installed by your payment processor prior to integration with
CRE.

Auto-settlement is NOT recommended if taking tips on the ICT-250.