Service and Maintenance
dizzer
®
L Series horizontal
– Assembly Instructions 2.2(2019-06) E inge
Page 53 of 60
© inge GmbH
6.2
Checks during Operation
Checking for Leak Tightness
NOTE
CAUTION, PROPERTY DAMAGE!
Fluid leakage
– especially where corrosive agents are involved –
may cause corrosion to appear on the components concerned.
Effective measures should be taken to avoid corrosion before it
occurs.
In the event of fluid escaping due to a leak, the affected area
should be properly rinsed down with salt-free or low-salt water
and rubbed dry.
6.2.1
Eliminating Leaks
Eliminate leaks by exchanging the corresponding O-rings or other components.
When doing so, note the warnings and instructions provided in section 5 Loading / Assembly, as applicable.
6.2.2
Exchanging Parts
When exchanging parts, only genuine parts from inge GmbH are permitted to be used.
6.3
Returning Modules
Returns shall only be accepted if this has been agreed in advance with inge GmbH and authorized in writing.
Returns that have been previously agreed and approved by inge GmbH are subject to the following mandatory
requirements:
All components must be rinsed and cleaned before being returned.
Modules must be preserved during storage and transport.
NOTE
FAILURE TO COMPLY WITH THE ABOVE INSTRUCTIONS!
Failure to comply with any of the requirements stated above will
result in inge GmbH refusing to accept the return of the modules;
inge GmbH reserves the right to invoice the sender for any
transportation or removal costs that may be incurred in this case.
