EonStorDS 1000 Series
41
PSU & Cooling Module (4U60 System)
The system is equipped with two redundant, hot-swappable PSUs at the rear
section of the chassis.
1
2
3
4
5
6
Each PSU comes with a
(1)
power socket and built-in
(2)
cooling modules to provide
system with airflow. A
(3)
single LED indicates the PSU status. When a power
supply failure occurs, the LED will light up red. The PSU is secured by a
(5)
retention
lever and when pressed, users can use the
(6)
extraction handle to pull out the PSU
from the enclosure. Should any of the LEDs light up
red
, please arrange for a
replacement immediately.
NOTE
The left and right PSUs have designated installation orientations. Please refer to the
label on the back of the enclosure.
There are two upper temperature thresholds: one for event notification and the other
for triggering higher fan rotation speed. The preset value for event notification can be
changed using the firmware-embedded configuration utility, while the fan speed
trigger cannot. Refer to the Firmware Manual for details.
