C A U T I O N
C A U T I O N
C A U T I O N
C A U T I O N
A S S E M B L I N G - T W O S I N G L E H E AT E R S J O I N E D ( WA L L
M O U N T E D O R C H A I N H A N G I N G )
1.
Take the first heater and place it face down on a flat surface.
2.
Take the second heater and place it face down and positioned parallel to the first heater.
3.
Push the bolts used to hold the wall brackets through the hole in the brackets on the rear
heaters and slide a shake-proof washer on all the threads from the protruding side.
4.
Slide the joining bars on each bolt and fit a washer and nut – do not fully tighten at this
point.
5.
Ensure the second heater is still parallel to the first and sitting flat.
6.
Slide the joining bars on each protruding bolt of the other heater to connect them
together and fit the washers and nuts.
7. Again, ensuring the heaters remain flat, fully tighten all four nuts to secure the joining
bars in place.
When wall mounting two Alpha H1 heaters joined
together in a horizontal manner, do not position the
heater at an angle more than 50° and less than 30°
as shown in Fig. F.
Always allow the heater to cool before attempting
to reposition/move. Never attempt to move the
heater while it is switched on!
Observe the minimum safe distance between the
heater body and inflammable surfaces and objects
when mounting.
Please refer to Table 1 for the recommended
positioning of the heater with regards to minimum
distances. Do not install the heater in a corner!
Keep out of the reach of children.
continued on next page…
Fig. F
WA L L M O U N T I N G - T W O S I N G L E H E AT E R S J O I N E D
Fig. G
Switch off/unplug the heater from the mains
supply when mounting or adjusting the heater
position.
6
S
E
E
T
A
B
L
E
1
F
O
R
M
IN
IM
U
M
H
E
IG
H
T
GROUND LEVEL
