•
When ceiling hanging the Alpha H1 heater, ensure the
minimum distance from the ceiling is adhered to as shown in
Fig. B.
•
Always allow the heater to cool before attempting to
reposition/move. Never attempt to move the heater while it
is switched on!
•
Observe the minimum safe distance between the heater
body and inflammable surfaces and objects when mounting.
•
Please refer to Table 1 for the recommended positioning of
the heater with regards to minimum distances. Do not install
the heater in a corner!
•
Keep out of the reach of children.
1. When wall mounting, securely fasten the L-shaped wall
brackets to the mounting surface using both of the fixing holes
in the short part of the bracket (see Fig. D on the next page for
mounting hole centres). Please refer to Table 1 for
recommended positioning of the heater. Please note. wall
fixings are not supplied. They should be selected to
substantially support the weight of the installation. If in doubt
contact a professional for advice! When hanging from a ceiling
two equal length and gauge chains are required and should be
selected with fixings that are adequate to hold the weight of
the heater. Again, if in doubt contact a professional for advice!
2. The heater should be mounted with the terminal box at
the bottom of the heater when being wall mounted.
3. When wall mounting, fix in the required angular position
by tightening the fixing bolts on the brackets at the rear of the
heater as shown in Fig. C on the next page.
The
heater
should face directly down when hanging.
4. Secure the supply cable so it is not resting on the body or
obstructing the air-vents.
Always isolate the heater from the mains supply when
adjusting the position.
Fig. B
Fig. C
TERMINAL
BOX
S
E
E
T
A
B
L
E
1
F
O
R
M
IN
IM
U
M
D
IM
E
N
S
IO
N
S
Fig. D
DRILLING HOLE TEMPLATE DIMENSIONS FOR WALL MOUNTED BRACKETS
7
