SYS644X-XX-P1 User Guide
Safety Warning
001703 Rev. A
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION
iv
Confidential and Proprietary
– Inforce Computing, Inc.
Provided under NDA
IMPORTANT SAFETY & REGULATORY INFORMATION
DO NOT DISCARD
– DOCUMENT MUST REMAIN WITH DEVICE
ENGINEERING DEVELOPMENT DEVICE - NOT FOR SALE OR LEASE
This device is intended for Laboratory Use Only!
Do Not Operate in Residential or Open Office Environment!
SAFETY WARNINGS and CAUTIONS - Please pay attention to the following warnings and cautions
Installation
and
Maintenance:
Do
not
connect/disconnect
any
cables
to
or
perform
installation/maintenance on this device during an electrical storm.
WARNING
RISK OF ELECTRIC SHOCK
Do not attempt to modify or use the supplied AC power cord if it
is not the exact type and rating required.
Power Cord Requirements:
The connector that plugs into the wall outlet must be a grounding-type male
plug designed for use in your region. It must have certification marks showing certification by an agency
in your region. The connector that plugs into the AC receptacle on the power supply must be an IEC 320,
sheet
C13,
female
connector.
See
the
following
website
for
more
information
http://kropla.com/electric2.htm.
General Use and Set Up:
Care must be taken at all times to avoid dropping, spilling, or allowing objects
to be placed on the device. Due to the fact that electrical circuits are exposed on these devices, keep all
metal objects such as rings, watches, screw drivers, etc away from the devices and power supply.
Cooling Requirements:
Leave a minimum clearance area of 2 inches (5 centimeters) around the side,
front, and back of the development device for cooling purposes.
Thermal and Mechanical Injury:
Some components such as heat sinks, power regulators, and
processors may be hot; care should be taken to avoid contact with these components.