InFocus X2 multi-use perfomance, Service Manual, Page: 29 / 67

X2 Service Manual 29
Leveling Foot
The leveling foot (340-1118-xx) consists of a threaded foot and a retainer. Rotating the leveling foot
extends or retracts it in the bottom case. The shaft threads through the bottom case from the outside. A
circular retainer stops the leveling foot at its maximum extension.
The leveling foot is located at the right rear corner of the projector.
1 Remove the following items:
Focus and zoom rings (page 17)
Front bezel (page 18)
Rear bezel (page 37)
Top case (page 39)
2 Rotate the leveling foot clockwise to fully retract it into the bottom case.
3 Use a needle-nosed pliers to remove the retainer from the groove at the top of the leveling foot
shaft.
4 Rotate the leveling foot counterclockwise until it detaches from the bottom case.
Assembly Notes
♦
Replace the retainer in the groove at the top of the leveling foot shaft. Make sure the retainer fully
seats.
♦
Adjust the leveling foot so that it is level with the bottom of the projector.