InFocus X2 multi-use perfomance, Service Manual, Page: 15 / 67

X2 Service Manual 15
Elevator
The elevator is located in the front of the projector between the projection lens and the lamp housing. The
elevator is comprised of the elevator spring, elevator actuator, elevator shaft, and a rubber elevator foot.
All these parts are included in the elevator kit (505-1848-xx) .
Remove the Elevator Shaft
The elevator fastens to the bottom case between the projection lens and lamp housing.
1 Remove the following items:
Focus and zoom rings (page 17)
Front bezel (page 18)
2 Fully extend the elevator shaft. Then use a small flat-blade screwdriver to gently depress the stop
on the elevator shaft. This allows the elevator shaft to pass through the housing and out of the
bottom case.
3 Depress the elevator actuator as you pull the elevator shaft out from the bottom side of the
projector.
4 If you are replacing the elevator shaft, install the rubber foot on the new shaft.