SP7205 Service Manual
36
Assembly Notes
•
The lamp must be seated properly to fully ignite. Make sure the two alignment pins on the lamp
module engage the holes inside the lamp cavity.
•
Make sure the bail on the lamp module is folded down in storage position. It snaps into position.
NOTE
If the lamp door does not fit flush in the door opening, it is probably because the bail is not
completely folded down.
•
You must replace the lamp door for the projector to operate.
•
If you installed a new lamp module, follow the directions below to
reset the lamp timer
.
a
Power up the projector.
b
Hold down the two Brightness buttons on the projector keypad for 10 seconds.
c
After you reset the lamp timer, read the timer value to make sure it was reset. Navigate to the
About screen from the Main Menu, then view the Lamp Hour value. It should show 0 hours.
