21/22
Transmission Protocol:
You can select “udp unicast” or “udp multicast”.
Scaler Setting:
You can set the output resolution.
Download EDID:
You can download the EDID binary file of the display device
connected to the Decoder. The EDID file can be used as the User EDID file to
be uploaded to the Encoder.
Video Timeout Setting:
You can set the timeout to turn off the video output
when no input video signal is detected. 0 means never close.
ID Setting:
Local ID:
You can set the ID of the Decoder. (After setting the ID, the IP will
change. You need to press and hold the (CH SELECT) UP button on the front
panel of the Decoder for 5 seconds to check the IP address, and then re-enter
the new IP address on the web page to continue setting).
Max Channel ID:
You can set the maximum range of Source Selection ID that
can be set. When it is set to 0, there is no limit to the setting range of Source
Selection ID.
Source Selection ID:
You can select the ID of the Encoder to be the input
source.
Picture Setting:
You can configure the picture parameters (Brightness,
Contrast, Hue and Saturation)
.
■ Settings Page
On this page, you can set Network settings, configure Security Module, modify
username and Login Password as required.