9/22
11
HDMI OUT
HDMI output port, connect to an HDMI display device such as
TV or monitor.
12
LAN (POE)
100M/1G Network port. Connect to a Switch/Router/Hub for
data transmission or POE function.
13
Link Signal
Indicator lamp
(Green)
▪ Illuminating: The network cable is connected normally.
▪ Dark: The network cable is not connected well.
14
Data Signal
Indicator lamp
(Yellow)
▪ Flashing: There is data transmission.
▪ Dark: There is no data transmission.
15
DC 12V
The device can be powered via two methods:
▪ Local DC 12V/1A power supply
▪ POE from Network Switch. Device acts as PD mode.
When the Switch supports POE function, DC power supply
is not needed.
Description of the LED screen and CH SELECT buttons (For the Decoder).
1, After the system is powered on, the Decoder’s LED screen will show the ID of the
connected Encoder (000 by default if not set).
2
,
Press and hold the UP button for 5 seconds, the Decoder’s LED screen will show in
sequence “IP:", "xxx", "xxx", "xxx", "xxx", which is the IP address of the Decoder.
3, Press and hold UP + DOWN buttons at the same time for 5 seconds, then release to
enter the “Configuration” mode with “CFN” displaying on the LED screen.
4, For Channel ID settings, press the UP or DOWN button to display the current ID
number (e.g. 001) on the LED screen. Press and hold UP + DOWN buttons for 5
seconds, then release to enter the “ID Settings” mode. The ID number (e.g. 001) on
the LED screen will flash at 1Hz, then press the UP or DOWN button to select the
Channel ID you desired, then press and hold UP + DOWN buttons for 5 seconds to
confirm the setting and stop flashing.
5, For output resolution settings, press the UP or DOWN button until the LED screen
shows “S00” (in which “S” refers to Scaler and “00” to resolution ID), then press and
hold UP + DOWN
buttons for 5 seconds, then release to enter the “Output Resolution
Settings” mode. The Resolution ID number (e.g. S01) on the LED screen will flash at
1Hz, then press the UP or DOWN button to select the Resolution ID you desired, then
press and hold UP + DOWN buttons for 5 seconds to confirm the setting and stop
flashing.