8/22
5.2 Decoder Panel
1 2
3
4
5
6
1
2
DEC
USB DEVICE
RESET
15 14 12 13
11
10
9
8
7
No.
Name
Function Description
1
POWER LED
(Red)
The LED flashes at 1 Hz during the system startup, and the
LED is always on after the startup is complete.
2
LINK LED
(Green)
Network connection status LED.
▪ Light on: Network is connected well, and there is video data.
▪ Light flashes: Network is connected well, but there is no video
data.
▪ Light off: Network is not connected.
3
LED screen
Displays IP address, ID etc information.
Note: When clicking the SHOW ME option of the
corresponding machine on the Controller, the LED screen of
the corresponding machine will flash “SHO”, so that you can
find the corresponding machine in the system.
4
CH SELECT
Used to set Decoder ID and other settings.
5
USB DEVICE
Connect to Key or Mouse.
6
RESET
System seset button. Press and hold this button for 5
seconds, the system will restart and restore factory settings.
7
IR OUT
IR signal output port.
8
IR IN
12V IR signal input port.
9
RS-232
RS-232 serial port, supporting signal pass-through and local
serial port control.
10
AUDIO OUT
Analog stereo audio output port. Connect to an amplifier or
loudspeaker through a 3-pin phoenix connector. It follows
the audio output of the Encoder.
POWER LINK
IR IN IR OUT
AUDIO OUT RS-232
HDMI OUT
CH SELECT
DC 12 V
L R TX RX