MHP ASSEMBLY INSTRUCTIONS
EXERCISE STRUCTURE ASSEMBLY
F.
Slide the shaft of the Height Adjust Arm through the bronze bushing in the L/H
Side Support and secure using a split shaft collar and 1 - ¼” x ¾” screw.
Install the screw into the shaft collar and tighten.
G.
Attach the Nylon Guide to the Height Adjust Arm using 2 – 3/8” x 3 ¼”
buttonhead bolts, 4 – 3/8” flat washers, and 2 – 3/8’ nuts.
NOTE:
The Height Adjust Arm should pivot parallel to the front of the Side
Supports. There should only be light pressure between the Nylon Guide and
the Chrome Selector Plate. If necessary, redo
Step E
with a washer between
the Chrome Selector Plate and the threaded posts of the R/H Side Support.
H.
Slide the shaft of the Exercise Arm through the bushings of the Cam and the
Pulley Arm. Assemble to the Height Adjust Arm at the center bronze bushing.
Make sure the pieces are assembled per the drawing view and secure using
a split shaft collar and 1 – ¼” x ¾” screw.
I.
Attach the large diameter end of the Gas Spring to the Height Adjust Arm
using a 3/8” x 1 ¼” bolt, 2 – 3/8” washers, and 1 - nut.
NOTE:
The end of the Gas Spring must be allowed to pivot so do not over
tighten the bolt and nut.
J.
Attach the small diameter rod end of the Gas Spring to the threaded post on
the L/H Side Support using 1 – 3/8” x 1 ½” bolt, 1 – 3/8” flat washer, and 1 –
3/8” nut. The nut is used as a jam nut against the threaded post to hold the
bolt in place. The Gas Spring should be parallel to the Height Adjust Arm and
be able to pivot easily.
6
Summary of Contents for CT-MHP
Page 1: ...CT MHP MULTI HIP For Service Call 714 821 4177...
Page 2: ......
