MHP ASSEMBLY INSTRUCTIONS
WEIGHT STACK, CABLE AND PULLEY INSTALLATION
K.
Insert Guide Rods into the base of the Loop Upright. Allow Guide Rods to
lean back away from the machine. Place one weight stack cushion on each
Guide Rod and slide down to the base. Apply lubricant to the Guide Rods
from the weight stack cushions to the tops of the Guide Rods.
Making sure that the recess for the weight labels is facing towards the
machine and that the three pads are facing down slide onto the Guide Rods:
15 – 10lb. Weights. Place the Top Weight and Cable on the Guide Rods with
the drilled hole facing the machine and slide down to the stack.
Before proceeding with the cable installation slide the loop of the weight pin
lanyard over the end of the MHP Cable down to the top weight. Bolt the first
10lb. weight to the selector stem using 1 - 3/8” x 5 ¾” bolt and 1 – 3/8” nut.
L.
Install Guide Rod Bracket onto top of guide rods. Place the MHP Cable over
one 4 ½” pulley and slide up between the plates of the Loop Upright at the
slot. Stand the weight stack assembly upright and bolt the Guide Rod Bracket,
Pulley and Loop Upright together using 1 – 3/8” x 2 ¼” bolt, 1 Cam Washer, 2
– 3/8” flat washers, and 1 – 3/8” nut. Do not tighten at this time.
M.
Place a pulley under the cable and insert between the plates of the Loop
Upright. Fasten using 1 – 3/8” x 1 ¾” bolt, 2 – 3/8” flat washers, and 1 – 3/8”
nut.
N.
Route the cable down to the base of the Loop Upright. Install a pulley over
the cable and attach between the two plates using 1 – 3/8” x 2” bolt, 2 – 3/8”
flat washers, and 1 – 3/8” nut.
O.
Route the cable below a pulley and place into the Pulley Bracket welded to
the Base Frame. Attach using 1 – 3/8” x 2” bolt, 2 – 3/8” flat washers, and 1 –
3/8” nut.
P.
Continue the cable up to the pulley plate on the Height Adjust Arm. Route the
cable over two pulleys and attach the two pulleys to the plate using 2 - 1 ¾”
bolts and 2 – 3/8” washers. Be sure that the cable is routed within the cable
retainer posts
Q.
Attach a pulley to the Pulley Arm using 1 – 3/8’ x 2 ¼” bolt, 2 – 3/9” washers,
and 1 – 3/8” nut. Route the cable below this pulley and hook the ball end of
the cable into the retainer welded to the Cam..
8
Summary of Contents for CT-MHP
Page 1: ...CT MHP MULTI HIP For Service Call 714 821 4177...
Page 2: ......
