MHP ASSEMBLY INSTRUCTIONS
EXERCISE ARM
R.
Attach the Roller Assembly to the Exercise Arm using 1 - 3/8” x 3/4” bolt and
1 - 3/8” washer.
CABLE ADJUSTMENT
Note:
Before proceeding make sure that all the bolts are tight except for the bolt
installed at
Step L.
at the Cam washer.
S.
Once the Multi-Hip is completely assembled, loosen the bolt that attaches the
pulley and Guide Rod Bracket to the Loop Upright (installed at
Step L.
).
Raise or lower the bolt and pulley to remove slack from the cables. Cable
slack may also be added or removed by adjusting the threaded stop on the
Pulley Arm. Make sure that the Weight Pin still engages all weight plates with
the Selector Stem. Once the cable tension is correct, rotate the Cam Washer
so it rests against the triangle support and re-tighten bolt.
CAM SHROUD
T.
Attach the Cam Shroud to the Height Adjust Arm using 2 – 3 ½” bolts, 4 –
3/8” flat washers, 2 – 3/8” nuts.
PLACARDS AND LABELS
U.
Position the Height Adjust Arm parallel to the floor. Remove the backing from
the foam tape on the Instruction Placard. Align the Instruction Placard to the
Cam Shroud and attach.
V.
Attach Weight Labels in recess provided on front of Weight Plates. All the
recesses should be aligned and to the right as you face the weight stack.
SHROUD HOLES AND SHROUD OPTION
W.
If no Optional Shroud Kit was purchased install plastic caps in all 12 shroud
holes. If installing Shrouds, fasten to Loop Upright using 6 – 3/8 x 2 ½” bolts,
12 – 3/8” flat washers and 6 – 3/8” nuts (hardware found in Shroud box).
10
Summary of Contents for CT-MHP
Page 1: ...CT MHP MULTI HIP For Service Call 714 821 4177...
Page 2: ......
