13
12
"S"
Shape
Special Bounce
Sp
i ral
Alon g Wa l l
Sp
ir al
Sp
ira l
Polygonal Sp
i ra l
Sp
ir a l
Vacuum
Operation
To keep your vacuum at top performance, please follow the maintenance steps
below after each use.
Make sure to turn off the vacuum power before doing maintenance.
•
R
emove any debris or hairs that might tangled on the roller brush and side
brush
•
Take out the dustbin and empty the trash inside.
•
Clean the filter with included small cleaning brush.
Y
ou can also wash the
filter with tap water and let it air dry before ne
x
t use
•
R
eplace wore out brushes and filter regularly.
Maintenance
Tips
Check the wheels regularly and remove any hairs or debris that might wrapped
around the wheels.
Occasionally, one of the driving wheels might wear out first after extended period
of use. In case this happened, the vacuum will always turning in circles in one
direction and you need to get a replacement wheel.
If your vacuum is always turning circles in counter-clockwise direction, there is a
problem with the left wheel. Otherwise, the right wheel is not working properly.
To replace a defective wheel, turn the vacuum upside down and remove a small
screw to open wheel cover. Then, unplug a power connector and you can take out
the wheel assembly.
Double check the marking on wheel assembly case (L/L2 or R/R2), so you can
get the correct replacement part.
Main Wheels
You can use this automatic robot vacuum in
AUTO
cleaning mode or
SPOT
cleaning
mode.
AUTO
cleaning mode:
AUTO
cleaning is the most common way to clean your floor. In automatic cleaning
mode, the vacuum will go through five pre-programmed moving patterns to provide
thorough coverage of the cleaning area. UV light is automatically turned on once
vacuum starts cleaning.
To perform
AUTO
cleaning, just press Power button on control panel to turn the
vacuum on, then press Start button to let it run.
The default cleaning time is 80
minutes
You can use remote control to customize
running time in 10 min. increment from 10
minutes
to 80
minutes
At the end of cleaning cycle, the vacuum will beep and stop running. If the
POWER/
CHARGE
indicator is solid blue at this time, the vacuum still has power left. You can
let it run again until the
LOW BATT
ERY
red light is shown on control panel.
SPOT
cleaning mode:
To perform
SPOT
cleaning, put the vacuum in the place you want to clean and press
SPOT
cleaning button on remote control. The vacuum will start running in spiral
pattern for intense cleaning around the area.