14
15
Press “GO” (for about 1 second) on the self-charging base, and you will see
Battery, Brush and GO icons turned on (as shown below) on the left side of LCD
panel. This indicates that the QQ2 Plus vacuum will automatically start a
cleaning cycle right after the battery is fully charged.
Press the “GO” button again to turn this function off.
Note: QQ2 Plus vacuum
cleaner will only run one cleaning cycle after “GO” button is selected.
If you hold down “GO” button for 5 seconds, the QQ2 Plus on the self-charging
base will leave the base and begin the cleaning right away, no matter whether
the battery has been charged in full or not. This function works the same way
as you push “START” button on the remote control on Section 7.
When the QQ2 Plus is being charging on the self-charging base, you can direct
the QQ2 Plus to begin cleaning when you press “START” button on your remote
control.
Illustration 2
Illustration 1
Illustration 3
Illustration 4
QQ2 Plus Series
QQ2 Plus Series
QQ2 Plus Series
Operations