18
Forward
Left
Right
Mode
Power ON/OFF
Vacuum Moror ON/OFF
Start/Stop
Reverse
Timer
Collided
UV light
Home
ON/OFF: After power on main unit (by push down the Main power button), you
can press ON/OFF keypad to control QQ5.
START/STOP:Press
the
Button to begin the automatic cleaning of the room.
Or to stop the activity of the unit, and it will emit a long sound.
Timer:
Use
this
button
to
set
the cleaning time of the QQ5.
UV: Control the UV light turn on or off.
VAC: Control vacuum motor on or off.
COLLIDED: Control unit cleaning method by soft-touched bumper or
non-collided.Battery Installation and Removal
Home: Use this Button to make QQ5 go back to the charging base.
MODE: Movement pattern selected, press the keypad once to make the unit clean
in :"1" Spot Spiral ( From small spiral to bigger, then bigger spiral to
small, cycling ) "2" Special Bounce, "3" Along wall, "4" S sharp,
"5" Polygonal Spiral, "A" Automatic.
LEFT/RIGHT/REVERSE:Use these buttons to manually drive the unit to the
right, left and backward
FORWARD: When press Forward, QQ5 go forward and the suction fan is working,
until user release the keypad. If touched obstacle, QQ5 will return.
(
If the last power off QQ5 was over 24Hr, for power saving and battery
life reason, you can not power on by remote control, please power on by
Main power button)
1.
2.
3.
4.
5.
6
.
7.
8.
9.
10.
10.
Function of each Button:
Remote Control Function
Note:
If the two symbol are all light up (before you s tart setting), please
clear previous ID of Main unit. You can follow the step of instruction f.
c) Let the sonic wall start to study:
If the three symbol are all light up
，
please clear previous
ID of Main unit
；
If the any one of three symbol is not light up,
please follow below steps.
Step 1: Power on sonic wall the power LED light up ;
Step 2: Use one of toothpick to inset the hole at the back of the sonic wall and
press down, when it emit ’’BI’’ sounds
，
one of the three symbol
(must light off before) will light up, it means the sonic wall
complete the study .
Note:
If there are more sonic walls need to study, please operate above steps
again, and at most you can play three sonic walls at the same time.
d) Let the remote control start to study
：
1 Take out the battery to make sure the remote control is power off.
2
Press the Left and Right buttons at the same time. (Please do
not press any other buttons)
3
Insert the battery for remote control. (please do not release the Left and
Right buttons)
4
When heard DI-DI’’
’’
sounds
，
and the display symbol
will light up
（
do not care if it was light before
）
, it means the remote control
complete study or renew the ID.
e) Let the main unit exit study mode:
Push the power button to exit the study mode ,and the main
unit complete the study.
f) Clear previous information of Main unit:
Press the Start / Stop button all the time, until heard DI - DI ’’
’’
sounds,
and all of six indicator lamps symbol are light off, it means cleared previous
ID of main unit already,
，
and you must reset all of ID for charging station,
sonic- wall, Remote control.
Setting ID with Main unit
