8
7
1
SHOT
or
2
PATRN
z
Enter “72, SHOT” or “3, PATRN” to call up Pattern 3;
7
2
SHOT
or
3
PATRN
z
Enter “73, SHOT” or “4, PATRN” to call up Pattern 4.
7
3
SHOT
or
4
PATRN
PTZ camera will repeat the tour recorded automatically.
Pan Left
Automatically
Zoom In
Automatically
Call up the defined pattern in above example
Note:
under PELCO-P/D protocol, enter one of the above code
commands to recall the designated pattern repeatedly. While under
INFINOVA protocol, enter one of the above code commands to
recall the designated pattern once;
enter one of the following code
combinations to recall the designated pattern repeatedly:
z
Enter "69, SHOT" + "70, SHOT" to call up Pattern 1 repeatedly;
z
Enter "69, SHOT" + "71, SHOT" to call up Pattern 2 repeatedly;
z
Enter "69, SHOT" + "72, SHOT" to call up Pattern 3 repeatedly;
z
Enter "69, SHOT" + "73, SHOT" to call up Pattern 4 repeatedly.
The operation of setting and calling up a PATTERN is different if
converting different protocols to Up the Coax. For detailed
operation, please refer to Section 7.4.
5.6 Special Operation
V1492 series high-speed PTZ cameras provide some shortcut
operations besides powerful menu programming function. Below is
the instruction on shortcut operations controlled by Infinova’s
V2117 keyboard.
1. AUTOSCAN
Operation:
Place the key switch at the OPERATE position; enter
“99, SHOT” to call up AUTOSCAN function.
2. TOUR
Operation:
Place the key switch at the OPERATE position; enter
“97, SHOT” to call up the current edited TOUR
3. WIPER
There are another two ways to activate the wiper except for menu
mode:
1. Activate the wiper with special preset
If WIPER is set to OFF in menu, entering commands “100, SHOT”
under the position “PROGRAM” can activate the wiper. The wiper
will stop after three-round running. Besides, it will stop if any other
operation occurs. If entering commands “100, SHOT” under the
position “OPERATE”, the wiper will be turned off.
2. Activate the wiper with special function keys
Entering commands “1, ON” under the position “PROGRAM/
OPERATE”, the wiper will be activated. The wiper will stop after
three-round running. If entering commands “1, OFF”, the wiper will
be turned off.
Note:
“ON” and “OFF” keys are both in “Auxiliary” area of the
keyboard. After calling up wiper with keyboard, deflect the joystick
will turn off the wiper.
