9
Ordercode: 41560
Infinity iM-2515
Control Modes
There are 4 modes:
•
Stand-alone
•
Master/Slave
•
DMX-512 (23CH, 123CH)
•
DMX-512+ArtNet (100+15CH)
One Infinity (Stand-alone)
01)
Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02)
Plug the end of the electric mains power cord into a proper electric power supply socket.
03)
When the Infinity is not connected with a DMX cable, it functions as a stand-alone device.
Please see pages 16-22 for more information about the Stand-alone Mode.
Multiple Infinitys (Master/Slave control)
01)
Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02)
Use a 3-pin/5-pin XLR cable to connect the Infinity.
The pins:
01) Earth
02) Signal -
03) Signal +
03)
Link the units as shown in fig. 03. Connect the first unit's DMX "out" socket with the second unit's "in"
socket, using a DMX-signal cable. Repeat this process to link the second, third, and fourth units.
You can use the same functions on the master device as described on pages 16-22. This means that
you can set your desired operation mode on the master device and all slave devices will react the
same as the master device.
Multiple Infinitys (Master/Slave control)
Fig. 03
