Application Kit TC2X5
Hardware Manual
Application Kit Information
User’s Manual
3-4
V 2.0, 2013-05
– D109 up to D112 (blue) -> toogle LEDs connected to P33.8 ... P33.11
– D108 ESR0 (red) -> RESET LED indicate the reset state of the board
– D107 +5V (green) -> +5V power supply indication
– D302 ACT (green) -> on board miniWiggler JDS is ACTIV
– D301 RUN (blue) -> Debug RUN mode (switched by DAS Server)
3.6
Clock
On the board is a fixed crystal wiith 20MHz assembled. You can change this by replacing
Y101 (soldered).
3.7
USB Connector
The USB connector is used for connection to a PC. Via the USB it is possible to power
the board, using the ASCLIN0 as serial connection via USB and Debugging via DAS. For
the pinout of USB socket see
.
NOTE: Before connecting the board to the PC, make sure that the actual DAS software
is installed on the PC. For actual DAS software please contact your local FAE.
The software can also be found on the
3.7.1
Serial Connection to PC
After the first connection of USB to a PC the needed driver will be installed automatically.
During this there will be created a new COM port on PC. This COM port can be used to
communicate with the board via ASC0 of the device (e.g. bootstrap loader).
3.7.2
miniWiggler JDS
The miniWiggler JDS is a low cost debug tool which allows you access to the JTAG of
the device. Make sure that you have the latest DAS release. Debugging is possible via
the DAS Server ‘UDAS‘. Please contact your prefered debug vendor for support of DAS.
If you have connected the board to the PC and there runs the DAS server, then a working
connection is visible via the green ACTIV LED.
The status RUN LED is switched on/off through the DAS Server, depending on the used
debugger (client).
IMPORTANT: Make sure that there is no or a tristated connection on X301 (OCDS1) if
the ACTIV LED is on.
Downloaded by [email protected] 09/08/2019 14:06:40
