Application Kit TC2X5
Hardware Manual
Application Kit Information
User’s Manual
3-5
V 2.0, 2013-05
3.8
Beeper
The board has an electro-acoustic transducer which can be used for an acoustic output.
The transducer is connected to pin P33.0 and needs a 2048Hz frequency.
3.9
MultiCAN
On the board is oneCAN transceiver connected to the MultiCAN on TC2X5 node 0. The
transceiver is connected to an IDC10 plug. For the pinout of IDC10 plug see
.
You can use a IDC female connector with crimpconnector, flat cable and SUB-D 9 plug
with crimpconnector to have a 1:1 adapter to SUB-D 9.
3.10
LIN
On the board is one LIN transceiver connected to the ASCLIN1 on TC2X5. The
transceiver are connected to one IDC10 plug. For the pinout of IDC10 plug see
. You can use a IDC female connector with crimpconnector, flat cable and
SUB-D 9 plug with crimpconnector to have a 1:1 adapter to SUB-D 9.
3.11
Ethernet
The Application Kit provide a RJ45 connector (X204) for twisted pair ethernet
connections.The board use a Lantiq Giagabit PHY PEF7071 as physical interface
device. For more information about the ethernet modul see TC2X5 User’s Manual, about
the PHY see the PEF7071 datasheet. For the pinout of RJ45 see
.
3.12
Other peripherals
For all other peripherals there are no special plugs on the board. Many of the peripheral
signals are available on the two standard connectors X102 and X103. See
3.13
Toggle LED’s
Port 33 pin 8 up to pin 11 are connected to single LED’s (D109... D112) and can be
controlled by Software. This status LED’s are low active.
3.14
Debug System
3.14.1
OCDS1
The OCDS1 signals are connected to the IDC16 plug (X301). They work with the port
supply of +3.3V. For pinout of the connector see
debugger to this connector.
Downloaded by [email protected] 09/08/2019 14:06:40