Infineon Aurix TC275 Lite Kit 1 Series, User Manual, Page: 12 / 25

Aurix
™ Lite-Kit V1.1
Hardware Description
Board Users Manual 12 Revision June, 2020
3.2 Solderable Pin Bridges
Some resistor bridges enable/disable or changing functions of specific signals in Table 2.
To disable the signals, the resistors have to be removed. To enable, the resistor has to be assembled.
For example : Desoldering the intialy assembled resistor R33, disables the Potentiometer and the analog Signal
AN0 of the Aurix, making it usable for other purposes.
Table 2 Signal mapping of the 0 Ohm Pin Bridges
Resistor Res. Assembled Signal Size
(imperial) Comment
R31 1k
Ω
no P14.3 (Aurix) 0402 Assemble if needed, but overboots
then P10.5/P10.6
R37 0
Ω
yes XTAL2 (Aurix) 0805 Serial resistor to reduce oscillator
aplitude if needed.
R39_opt 0
Ω
no USR0 (ADBUS6) (Debug) 1210 Placeholder, do not assemble
R40_opt 0
Ω
no USR8 (ACBUS5) (Debug) 1210 Placehoder, do not assemble
3.3 Arduino Compatible Connector
The mapping of GPIOs and Aurix
™ pin functions to Arduino compatible functions can be found in Figure 5. The
Arduino compatible connector supports

SPI interface (SPI_xxx)

I2C interface (I2C_xxx)

UART interface (UART_xxx)

PWM signal outputs (PWM0-13)

ADC input (ADC0-5)

Interrupt input (INT0-1)
Note that all pins are cabable of offering more functions than mentioned in Figure 5. For more information about
all pin functions, we want to refer you to the
Aurix
™ TCX27X family datasheet
(page 13 ff).