Infineon Aurix TC275 Lite Kit 1 Series, User Manual, Page: 11 / 25

Aurix
™ Lite-Kit V1.1
Hardware Description
Board Users Manual 11 Revision June, 2020
3.1 Shield2Go and MikroBus
™ Pinout
The pin connectors for the Shield2Go Connectors 1 and 2 and the mikroBus
™ can be used to extend the
evaluation board or to perform measurements on the Aurix
™ TC275. Figure 5 shows the available signals at
these connectors. The pin table is also printed onto the top and bottom side of the Aurix
™ TC275 Lite-Kit.
Shield2Go Connector 1 Shield2Go Connector 2
Aurix™
Pins Aurix™
Pins
1 +5V 5V
Aurix
Pins
1
+5V 5V
Aurix
Pins
2 AN16 AN1 RX P33.8 10
2
AN18 AN1 RX P20.3 10
3 AN17 AN2 TX P33.9 11 3 AN19 AN2 TX P20.0 11
4 P13.2 2) SDA
RST/GPIO
2
P20.9 12
4
P13.2 2) SDA RST/GPIO2 P20.10
12
5 P13.1 2) SCL GPIO1 P32.2 13 5 13.1 2) SCL GPIO1 P32.3 13
6 GND GND CS P11.2 14 6 GND GND CS P11.10 14
7 VEXT 3V3 SCLK P10.2
1)
15 7 VEXT 3V3 SLCK P10.2
1)
15
8 P00.4 INT/GPIO3 MOSI P10.3 1) 16 8 P10.8 INT/GPIO3 MOSI P10.3 1) 16
9 P20.12 PWM/GPIO4 MISO P10.1
1)
17
9
P20.13 PWM/GPIO4 MISO P10.1
1)
17
mikroBus™ Connector
1
AN26 AN
PW
M P2.8
16
2
P10.6 RST INT P10.7 15
3
P10.0 CS RX P15.1 14
4
P10.2
1)
SCK TX P15.0 13
5
P10.1 1) MISO SCL P13.1 2)
12
6
P10.3
1)
MOSI SDA P13.2
2)
11
7
VEXT 3.3V 5V +5V 10
8
GND GND GND GND
9
Figure 5 Signal mapping of the pin headers for Microbus and Shield2Go Connector 1 and 2
Note:
1) The SPI buses MOSI, MISO and SCK are shared on the Shield2GOs-, mikroBus™- and Arduino connectors.
2 )
The I2C buses SCL and SDA are shared on the Shield2GOs, mikroBus™ and Arduino connectors and are additionally connected with analog Inputs AN24
and AN25. You can not use I2C and analog reading functions of AN24/AN25 simultanously.