Ref. 004001001200
Rev.3: 17-01-2021
25
9.
Jumper Configuration
General Jumper Configuration
This jumper makes the choosing between connecting
MAX232 to pins 0,1 of the Arduino Leonardo or with the
MAX485. In order to use the RS-232 Hardware Serial
protocol both RS-232 must be connected to the D1/D0. In
order to use the RS-485 Hardware Serial protocol both RS-
485 must be connected to the D1/D0.
This jumper zone makes the choosing between connecting
the inputs Q0.9, Q0.8 to pins 4 and 8 of the Arduino
Leonardo respectively, or connect the RS-232 ports to
activate the Software Serial RS-232. In order to use the
inputs Q0.9, Q0.8 the jumper must be connected to the
pins 4 and 8. So Q0.9 must be connected with D4 and Q0.8
must be connected to D8.
*The jumpers that are not connected to the middle jumpers MUST NOT be Connected
anywhere.
JUMPER ZONE 1
LEFT
RIGHT
RS-485
RS-485
D0
D1
RS-232
RS-232
JUMPER ZONE 2
LEFT
RIGHT
Q0.9
Q0.8
D4
D8
RS-232 SS
RS-232 SS
Summary of Contents for DALI 20
