System1000_GB_130705.doc
Page
6
11. Checking the Components
11.1 Keyfob
To arm the siren, press the ON button on the keyfob once. The siren emits a bleep, and the LED flashes
once. If the siren does not react, keep a minimum distance of 1m to the keyfob and press the ON button
once more.
To disarm the siren, press the OFF button on the keyfob. The siren bleeps twice, and the LED flashes.
11.2 Panic Alarm
The system has a panic alarm facility. Hold the keyfob ON or OFF button down for at least 3 seconds. The
siren will sound for 15 seconds. After this, the siren stops automatically. The siren cannot be silenced with
the keyfob if the panic alarm is activated.
WARNING: The siren is loud. Take precautions to prevent damage to your hearing.
11.3 PIR
Sensors
First check the radio link to the siren. Place a
PIR sensor on a table or on the floor, and
wave a hand in front of the lens. The LED
behind the lens will flash (if the LED and the
power saver jump link are still covered). The
LED on the bottom of the siren should also
flash once.
Check that the PIR sensors activate the alarm.
To arm the siren, press the ON button on the
keyfob. The siren emits a bleep, and the LED
flashes once. After 10 seconds the siren emits
a second bleep. Now the system is armed!
Repeat the test with the PIR sensor, the siren
should trigger an alarm after 10 seconds.
To silence and to disarm the siren, press the
OFF button on the keyfob. The siren bleeps
five times, and the LED flashes once.
fig. 9
