Indel Webasto Isotherm SED00036DA, Instruction Manual

Page: 40 / 212

ISOTHERM Digital Display
40
purposes, if the cable may be pulled, insert a plastic clamp on
the cable near the rubber gland Fig. 18 . Insert the white 3-pin
connector on the display circuit board Fig. 19-20 .
• Insert the overhanging part of the circuit board under the edge of
the frame, tiling the display. Then delicately lower it until you feel
resistance to insertion Fig. 21-22 .
• At this point, rest two left hand fingers and two right hand fingers
on the 4 buttons, press the board forward and slightly downward.
Once some resistance has been exceeded, the board will inserted
inside the designated housing Fig. 23-24 .
• To remove the display from the support frame, use a flat-bladed
screwdriver with maximum dimensions 0.5x3mm [0.02x0.12in],
insert the tip of the screwdriver inside the extraction position,
see Fig. 25 for a depth of approximately 10mm [0.4in], push
downward slightly until the display lifts from the housing. The
display should now come out from the housing, possibly with the
aid of a finger to carefully lift the bottom central part of the board
Fig. 26 .
Getting started:
Functions:
- The Digital Display has the direct functions of:
- Turning the product on and off without opening the refrigerated
compartment
- Instant display of the actual temperature inside the refrigerated
compartment
- Display and/or change of the set temperature with a simple press of the up
and down keys
- Selection of permanent energy savings operation
- Instant display of any operating faults
- The product is equipped with a Soft Start function. The number of
compressor revolutions is kept to the minimum allowed for approximately
30 sec. at every start of the compressor. This allows you to balance the
internal pressures on the gas circuit, preventing possible compressor blocks
and allowing the control unit to compare and process all the data set and
collected and decide whether to keep an energy-saving configuration or
increase cooling power.