inada HCP-G900, Operating Instructions Manual

Page: 11 / 52

8
[BEFORE USE]
How to Transport or Move the Chair
Turn the main power switch to OFF and disconnect the plug from the wall outlet before moving the chair.
Install the remote controller stand to the armrest before installing the armrest to the chair.
How to Install the Armrests
Install the armrests according to the following procedure.
① Recline the seat back. ② Insert the arm rest clasps into the
installation position on the chair,
and slide them forwards.
③ Insert the installation screws
(long) into the screw holes, and
tighten using the T-shaped wrench
provided.
Insert
Slide
Tighten
Caution
● Always fi x the arm rest in place with the screws, and check that the screws are not loose.
→ If the screws are not installed or not tightened correctly, they may come out during use, which is dangerous. Always check the screws.
Installation
screw (long)
L-shaped
Wrench
Screw hole
Insert
Clasp
Installation
location
■ The chair is very heavy, so be careful not to hurt your lower back when transporting or moving it.
■ The remote controller is attached to the chair, so make sure that it does not fall when moving the chair.
Caution
● Do not move the chair while someone is in it.
● Be sure to disconnect the power cord from the wall outlet before moving the chair.
→ The power cord may be damaged, resulting in fi re or electric shock.
Caution To Move with the Wheels To Carry
Do not pick up or push
the back cover.
Recline the seat, hold the carrying handles
(leg), and then lift the front part of the chair
to move using the wheels. Fully recline the seat back and carry the chair
by holding the carrying belt on the back
cover and foot rest carrying handles (legs).
Back Cover
Carrying belt