7
40 cm
(16 inch)
Operating Manual
Operating Guide
AC Cord
Remote Controller
Stand
Chair
Armrest
One each on left and
right sides
L-shaped Wrench
Installation Screw
(short) x 2
Installation Screw
(long) x 2
[BEFORE USE]
BEFORE USE
●
This product is shipped with the reclining seat back in its fully reclined position. Be sure to raise the seat back to its
fully upright position.
●
Do not expose the chair to sudden bursts of heat. If the room where the chair is to be used is cold, turn the heat up
slowly. If the chair is moved from a cold place into a heated room, wait one hour before using the chair.
→
Condensation could occur in the moving parts of the chair, which may compromise performance.
Installation
Allow for at least 40 cm (16 inch) clearance behind the chair so as to be able to recline the seat back fully without
obstruction, and allow enough space in front of the chair for people to pass.
Caution
●
Do not install the chair in an area of high humidity, such as a bathroom or sauna.
●
Install on a fl at, level surface only.
●
Do not use in areas of high debris or dust content. Do not use where the ambient temperature is 40°C (104°F) or over.
●
Do not install the chair where it can come into contact with direct heat, such as direct sunlight or a radiator.
●
Keep fi re sources such as cigarettes and ashtrays away from the chair.
●
To avoid damaging fl oor surfaces and to minimize the chair noise, it may be better to install the chair on a carpeted surface or to lay a piece
of carpet under the chair.
(Do not use electric blanket.)
●
The chair is very heavy, so please be careful when unloading it so as not to damage fl oor surfaces.
●
Install the chair at least 1 m (39 inch) away from TVs, radios, and other audio or video equipment. Otherwise they may make noises aff ected
by the operation of the chair.
●
The load to the fl oor per 1 cm
2
(0.15 inch
2
) is approximately 3.0 kg (6.6 lb), with a person weighing 100 kg (220 lb) sitting on the chair.
Checking the Supplied Items
Check that the chair and the other items are all in the package.
Summary of Contents for HCP-G900
