DECIDE ON THE BLOCK LOCATION
PREPARE THE POWER SYSTEM
THE CONNECTION OF THE POWER CONNECTOR
It is better to place the controller away from the heater radiator. If you want to
hide the unit, take care of the long USB wire. You can immediately connect and
bring it out, so that in the future there will be no problems with access to the USB
connector.
You need:
џ
a 10 Amp fuse,
џ
an automotive relay,
џ
wiring.
The cross section of the supply wires and
the wire connection of DCCD have at least
2
1mm as there is some interference. The
larger the wire cross section is - the less noise
will be in the air.
2
The cross section of signal wires is 0.5mm .
Taking the supply circuit must be in close
proximity to the battery through the fuse 10-
15A, for example, immediately after the main
fuse. Make sure that the negative cable
(ground) is connected.
The scheme is standard: "+" battery > fuse > relay with switching current from
30A (must be triggered when the ignition is turned on) > DCCD unit. The fuse
should be as close as possible to the "+" of the battery.
If you do not have a special tool for crimping connectors, you can use the pliers,
followed by soldering the crimping place.
After the installation, check all connections for contact quality, the insulation of
contact points. In the car it is allowed to use a twist or a clamp connector when
connecting. It is recommended to use sealed connectors outside the cabin, and if
there are no any - twisting and subsequent soldering of the connection.
Ring all the circuits, making sure that when the ignition is switched on, the power
is supplied to the controller.
MT:
The coupling DCCD does not have any polarity,
i. e. just plug in "DCCD+" and "DCCD-" contacts.
AT:
When connecting the automatic box shank,
connect only the "DCCD +" of this connector. We
highly recommend the contact "DCCD -" for
connecting to the ground wire at the transmission.
1
2
DCCD
TYPE
1
GND
2
+12 V
3
DCCD +
4
DCCD -
3
4
FUSE
10A
IGN
DCCD Power
DCCD Ground
K2
+12V BATT
INSTALLATION
, page 1
If you have any questions, please write to
