Wireless M-Bus Range Extender /
/
User Manual Version 1.0
Page 9 of 32
Installation
The Wireless M-Bus Range Extender housing consists of mounting brackets for fastening on a flat surface. Installation height must not be
higher than 2 meters above ground to avoid any risks in case of falling down.
The figure below shows the positions of the LED, the Reed Sensor and especially the integrated PCB antenna.
For optimal RF performance please avoid any metal obstacles near the antenna area.
If possible, avoid to install the module directly next to other radio equipment.
After powering up the Wireless M-Bus Range Extender by connecting the battery cell to the power connector the Range Extender performs
its startup procedure and starts working depending on the current configuration.
Device activation and visualization of internal firmware status can be triggered by a magnet via reed sensor and will be signalized via led
For more details, please read the chapter
.
