RShell Reference Manual
18
.
Proprietary and Confidential
Revision 4.2, Copyright © 2009, Impinj, Inc.
4.2.4.8 Config Network NTP Command
The
config network ntp
command allows the user to statically configure NTP servers. These
servers are in addition to any provisioned through DHCP. The command parameters are shown
in Table 4-14.
Table 4-14 Config Network NTP Command Parameters
Command
Argument
Format
Description
add
<ntp server> <address>
Add a static server (identified by either an IP address or
hostname) to the list of current NTP servers.
del
<ntp server> <address>
Delete a statically configured server (identified by either
an IP address or hostname) from the list of current NTP
servers.
delall
Delete all the statically configured NTP servers from the
current list.
An example of the command is:
>
config network ntp add myntpserver.com
Status='0,Success'
4.2.5 Config RFID Command
The
config rfid
menu allows the user to set parameters of the reader’s RFID control interface; the
parameters are shown in Table 4-15.
Table 4-15 Config RFID Command Parameters
Command
Description
llrp
Sub-menu of LLRP-specific configuration commands.
resetstats
Reset the current RFID statistics.
4.2.5.1 Config RFID ResetStats Command
The
config rfid resetstats
command resets the RFID statistics maintained by the reader.
An example command and response is shown below:
>
config rfid resetstats
Status='0,Success'
4.2.5.2 Config RFID LLRP Command
The
config
rfid
llrp
command allows the user to configure the LLRP implementation. The
parameters are shown in Table 4-16.
Summary of Contents for RShell
Page 49: ...RShell Reference Manual...