Impex MARCY PLATINUM MP-3500, Owner'S Manual, Page: 13 / 31

STEP 4 (See Diagram 4)
A.) Attach the Seat Pad (#88) to the Seat Post (#6). Secure it with two M8 x 1 5/8” Allen
Bolts (#113) and Ø 5/8” Washers (#112).
B.) Insert the Seat Post into the opening on the Seat Support Frame (#7). Thread the 3
3/8” T-shaped Lock Pin (#73) into the nut on the Seat Support Frame to lock the
Seat at desired height.
C.) Insert one Foam Tube (#23) halfway through the hole on the Leg Developer (#8).
Push two Foam Rolls (#86) onto the Foam Tube from both ends. Plug two Foam Roll
End Caps (#59) into the Ends.
D.) Attach the Leg Machine Frame (#31) to the Rear Base Frame (#15). Secure it with
two M10 x 3 5/8” Allen Bolts (#96), one 5 ½” x 2” Bracket (#26), four Ø ¾” Washers
(#111), and two M10 Aircraft Nuts (#109).
E.) Attach the Rotating Cam Plate (#32) to the Leg Machine Frame (#31). Align the
holes and insert the axle on the Lever Frame (#33) through the holes. Secure it with
one Ø 1 ¼” Washer (#70) and one M12 Aircraft Nut (#110). Do not over tighten the
nut. The Lever Frame needs to swivel freely on the pivot.
F.) Adjust and secure the Lever Frame (#33) to the Cam (#32) with a 4” T-shaped Lock
Pin (#78).
G.) Insert the axle on the Lever Frame Handle (#34) into the opening on the Lever
Frame (#33). Secure it with one Ø 1 ¼” Washer (#70) and M10 Aircraft Nut (#109).
H.) Slide a 7” Swivel Tube Sleeve (#38) onto the tube on the Lever Frame Handle (#34).
I.) Push one Ø 4” Large Foam Roll (#58) onto Sleeve. Plug one Foam Roll End Cap
(#59) into the end of Handle.
J.) Slide one Foam Tube (#23) halfway through the hole on the Leg Machine Frame
(#31). Secure it with one M6x 3/8” Screw (#108). Push the 6 7/8” Grips (#67) onto
the Tube.
12