Imperial DABMAN i550 CD, Operating Instructions Manual

Page: 67 / 292

67
EN
Do not use the device in potentially explosive areas.
These include, for example, fuel storage areas, tank systems, or areas in which solvents are stored or
processed.
> Do not operate the device in areas with air contaminated with particles (e.g. flour or wood dust)
Malfunctions can take the form of heating of the device or smoke development from the device or the
device’s power adapter.
Loud or unusual noises can also be a sign of a malfunction.
> In this case, pull the power adapter out of the power socket immediately.
> Only touch the power adapter by the housing.
Never pull the power adapter out of the socket by the cable.
After a malfunction, the device must not be used until it has been checked or repaired by a qualified
person.
> IIf you bring the device from a cold to a warm environment, moisture can form inside the
device.
In such an event, wait approximately one hour before using the device again.
> Unplug the device from the power socket if you are absent for a longer period or during a
thunderstorm.
Take care to avoid contact with moisture, water or splashing water and do not place objects
filled with liquids –
e.g. vases – on or near the unit or the power supply.
> If foreign bodies or liquids get into the device or the power adapter, pull the power adapter
out of the socket immediately. Have the device checked by qualified personnel before you use it
again.
Otherwise, there is a risk of electric shock.
> Make sure that the device or the power adapter is not exposed to dripping or splashing water and
that there are no open sources of fire (e.g. burning candles) near the device or the power adapter.
> The power adapter must never be touched or handled with wet or damp hands.
2.4. Connect device
> Only connect the device to a properly installed, earthed and electrically protected socket.
>
Please ensure that the power source (socket) is easily accessible.
> Do not kink or crush any cable connections.
> Before putting the device into operation, check whether the voltage information on the device
matches the local mains voltage.
The specifications on the power unit must correspond to the local power grid.
> Only connect the radio to a properly installed socket of 220–240 V AC, 50–60 Hz.
> Place the radio on a firm, level surface.
> The device consumes power in standby mode. To completely disconnect the device from the mains,
the power adapter must be unplugged from the socket.
2. SAFETY INSTRUCTIONS