5
CHAPTER 2 OPERATING
2.1
SWITCHING ON OF THE APPLIANCE
To switch on the Control Panel, put the Main Switch (D1) on the “1” position.
ATTENTION
The operator cannot choose the setting of the operating mode “
STROKE COUNTER
” or
“
MINUTES COUNTER
”, but it is automatically pre selected by the Manufacturer during
the mounting operations.
STROKE COUNTER MODE
When the stroke counter panel is set for the STROKE COUNTER mode, the numerical display (D8)
visualises the number strokes to be effected during the test execution set by the operator; this value will
decrease during the working of the appliance.
In this operating mode the numbers on the display visualise the number of strokes from a minimum of 0
up to a maximum of 65.000.
When the appliance is turned on the Led (D7) turns on and the display shows the number of strokes set
in the last test before its switching off.
2.2
SETTING UP OF THE STROKES NUMBER
To set the number of strokes to be effected, just enter a value from 1 to 65.000 on the numerical
display (D8).
Press several times this button
until the first figure on the right starts blinking. Operate the
buttons
to set the desired value
Press the button
until the last figure but one on the right starts blinking. Operate the buttons
to set the desired value.
Press the button
until the middle figure starts blinking. Use the buttons
to set
the desired value.
Press the button
until the second figure on the left starts blinking. Use the buttons
to set the desired value.
Summary of Contents for BM255
Page 16: ......
Page 23: ...8 ENCLOSURE D ELECTRIC PANEL ...
