•
Power Cord Requirements
•
The power cord set (wall plug, cable and AC adapter plug) you received with your printer meets the requirements for use in the country where you pu
rchased your equipment.
•
Power cord sets for use in other countries must meet the requirements of the country where you use the printer. For more information on power cord
set requirements, contact your authorized dealer, reseller, or service provider.
•
The requirements listed below are applicable to all countries:
• The length of the power cord set must be at least 6.00 feet (1.8m) and a maximum of 9.75 feet (3.0m).
• All power cord sets must be approved by an acceptable accredited agency responsible for evaluation in the country where the power cord se
t will be used.
• The power cord set must have a minimum current capacity of 7A and a nominal voltage rating of 125 or 250 volts AC, as required by each co
untry’s power system.
Power Cord Protection
• To minimize wear on the power supply cord, the power supply cord should be routed away from foot traffic and contact with other objec
ts. Do not route the power cord under rugs or carpeting. The cord should never be severely bent, pinched, or twisted. Periodically inspec
t the power cord and each end of the cord for wear or damage. Unplug and replace the cord if it is damaged.
• If you use an extension cord with this unit, make sure that the total ampere rating on the products plugged into the extension cord does
not exceed the extension cord ampere rating.
Care During Use
• Do not walk on the power cord or allow anything to rest on it.
• Do not spill anything on the system. The best way to avoid spills is to not eat or drink near your system.
• When the printer is turned off, a small amount of electrical current still flows through the Printer. To avoid electrical shock, always unpl
ug all power cables, before cleaning the system.
• Unplug the system from the wall outlet and refer servicing to qualified personnel if:
-The power cord or plug is damaged.
-Liquid has been spilled into the system.
-The system does not operate properly when the operating instructions are followed.
-The system was dropped or the casing is damaged.
-The system performance changes.
3
