Instructions for Use and Guarantee Conditions
21
IML
-Instrumenta Mechanik Labor System GmbH
I
Parkstraße 33
I
69168 Wiesloch I
Phone +49 (0) 6222 6797-0
I
Fax +49 (0) 6222 6797-10
I
E-mail [email protected]
I
Web: www.iml.de
ENGLISH
Instruction
Trouble shouting (Some troubles, possible cause and remedy!)
The drilling needle rotates, but the slide does not move forward from the
rear position!
-
switch on the drill several times in forward running and see whether the slide moves!
-
remove clutch cap in the front plate and turn the central spindle clockwise a little by
means of a screwdriver.
-
if the problem occurs frequently, the clutch will have to be re-adjusted,
cf. section ’overload clutch’!
The drilling needle rotates, but the slide does not move forward nor backward
from any position!
-
re-adjust the clutch as described in the section ‚overload clutch’!
The drilling needle does not rotate, and the slide does not move at all!
-
the drill has not been set to any transmission stage!
-
the safety pin has sheared off owing to overload, cf. section ‚replacing the safety sin’!
The drilling needle does not rotate, the slide does not move, and a rattling noise
is to be heard during operation of the drill!
-
the drill holder of the drill has opened
-
the gearbox of the IML-RESI is damaged, please contact your dealer!
The drilling needle may jam in the material to be examined, if:
-
the power of your drill is too low
-
it hits hard, non-wooden materials (stone, splinter...)
-
a drilling process in green wood has been stopped and re-started more than several
minutes later and the needle has stuck in the wood during this time
-
the drilling instrument has been canted during the measuring process
If you should not be able to remove the needle from the drill hole by turning it, you
will have to remove it from the drill, cf. section ‚exchanging the drilling needle’!
If you should not succeed in removing the needle from the drill holder this way,
you will have to cut it off between the wood and the drilling instrument. The part that
remains in the drill holder will be removed as you would do for usual exchange of the
drilling needle and replaced by a new drilling needle!
C
CE Declaration of Conformity
We declare on our own responsibility that the above product complies with the
Following standards or normative documents: EN 50 144, EN55 014 (accumulator tools)
EN 60 335, EN 55 014 or EN 55 011, EN 60 555 (storage battery chargers) according
to the regulations of the guidelines 73/23/EWG, 89/336/EWG, 89/392/EWG, 98/37/EG.
The measuring instrument must not be opened by any person but the manufacturer
or an authorized service company. Otherwise, all claims for guarantee will become
extinct!
NOTE
